Contents
1 Aim
To provide colleagues with best practice guidelines for performing ultrasound bladder scans.
Ultrasound bladder scanning is a non-invasive procedure that measures urinary bladder volume. Bladder scanning should be used in preference to using an indwelling catheter to measure urinary residuals on the grounds of acceptability and low incidence of adverse effects (National Institute for Health and Care Excellence clinical guidance 97 2015).
Appropriate and timely use of the scanner can prevent unnecessary catheterisation, assist in the managing of incontinence and help diagnose urinary and bladder dysfunction.
2 Scope
This procedure applies to all Doncaster care group colleagues, whether in a direct or indirect patient care role.
Adherence to the procedure is the responsibility of all Doncaster care group trust colleagues, including agency, locum, and bank colleagues.
For Rotherham and North Lincolnshire colleagues should refer to your local guidelines.
3 Link to overarching manual
4 Procedure
The bladder scanner will only be used by a trained healthcare practitioner, for example, qualified nurse, health care assistants within the specialist continence service and also by some healthcare assistants on in-patient wards who have received training and are competent in the procedure. Outcome of bladder scan results should be recorded within the patients record on SystmOne.
4.1 Clinical Indications for use of bladder scanner
- To check for retention of urine, if symptoms suggest incomplete bladder emptying.
- To check for retention of urine prior to commencing anticholinergic therapy. Residuals over 100mls should not be commenced on anticholinergic therapy.
- To monitor urine output in those patients commenced on anticholinergic therapy to ensure bladder function has not been compromised.
- Assessing the degree of retention before catheterisation.
- Assessing volume of urine in bladder if catheter appears to be blocked or not draining.
- After a trial without catheter, evaluation of whether a patient is able to void and to what degree.
- Patients with neurogenic bladder should have regular bladder scanning to monitor residual urine, for example, for patients with progressive multiple sclerosis.
- Intermittent self catheterisation training aid.
- Biofeedback mechanisms.
- Aid bladder retraining.
4.2 Urinary retention
Urinary retention can occur for a variety of reasons including:
- a physical or neurological impediment which obstructs the flow of urine or prevents the detrusor muscle from effective contraction
- effects of medication including anticholinergic drugs, opiates and epidural analgesia
- psychological effects
- functional ability, for example, not being able to sit on the toilet properly to empty properly
- effects of surgery
4.3 Signs and symptoms of urinary retention
- Hesitancy.
- Nocturia.
- Straining to void.
- Sensation of incomplete emptying of the bladder.
- Post micturition dribble.
- Urinary tract Infection.
- Prostatic symptoms.
- Palpable bladder.
- Frequency.
- Urgency.
- Dysuria.
4.4 Contraindications for use
- If the patient has a wound where the scanner head would usually be placed.
- If the patient withholds consent.
4.5 False readings
- Anxiety about the procedure.
- Foley catheter.
- Intravesical mass.
- Obesity.
- Fluid filled cyst.
- Patient on their side during the procedure.
- Pregnancy.
- Volumes over 1000mls.
- Volumes under 100mls.
- Anatomical anomalies.
4.6 Care of the CUBEscan 700 and 900
- Storage, the scanner will be stored in the supplied case in a cool dry place. It is especially important to protect the probe head.
- Handling, always rest the probe on the rubber part of the handle.
- Cleaning of the scanner and the probe, the scanner and probe must be cleaned in accordance with both manufacturers’ guidelines and in line with infection prevention and control recommended practice which is Clinell wipes.
- Each locality will have a designated base for their bladder scanner. This base is to have a designated member of staff who will be responsible for ensuring the maintenance of the scanner is carried out according to the maintenance contract. When the scanner is due for calibration, or if the scanner is not working properly contact the continence health advisory service who will arrange the bladder scanner to be serviced.
The bladder scanners CUBEscan 900s will be annually serviced by De Smit Medical.
The CUBEscan 700 and 900s has a built-in battery, when the unit is on charge the green and orange lights signal the battery is having a bulk charge to increase the batter’s capacity fast. Once the orange light has gone out it is important to keep the scanner on charge for a further 2 hours as the battery will still be charging but at a slower rate (green light permanently on). Should the battery appear to lose its charge quickly then operate the bladder scan by the mains and when possible charge the unit overnight.
- Ensure the printer paper is loaded properly in the scanner.
- A supply of cleaning wipes and ultrasound gel should be kept with the scanner.
- All manufacturer’s instructions must be adhered to and care taken to prevent damage to the equipment. Should any part of the equipment be damaged, this should be reported immediately.
- Please note that in transit the temperature may fall, and the scanner can become too cold. If the unit does not switch on after holding the power button down for two seconds or the screen flickers put the scanner in a warm environment for approximately 30 minutes before retrying.
4.7 Methods
There are four accepted methods of carrying out the scan procedure (Addison 2000):
- a bladder scan is performed before and after voiding to assess the residual volume
- the patient is asked to void, and then a scan is taken within 10 minutes
- the bladder scan is performed first and if any urine is present the patient is asked to void into a jug which is then measured. The difference between the volume in the bladder according to the scan and the volume of the voided urine gives the residual volume
- the patient is given large amounts of fluid to drink. When they experience the urge to void a scan is taken. The patient is then asked to void. After voiding a second scan is taken to give the post void residual
4.8 Performing the procedure
The steps for performing bladder scanning are as follows:
- explain the procedure to the patient and gain consent
- ensure privacy
- decontaminate hands
- assemble the bladder scanner according to the manufacturer’s instructions, switch the scan on and set the scanner for the appropriate gender or condition
- assist the patient into a supine position with head raised
- adjust clothing to expose the lower abdomen
- place an ample quantity of ultrasound gel on the probe head. Palpate the patient’s pubic bone and place the probe midline on the patient’s abdomen, approximately one inch (3 fingers above the pubic bone)
- standing at the patient’s right side, place the probe on the gel and aim towards the expected location of the bladder. For most people this means tilting the probe slightly towards the patient’s coccyx
- press the “SCAN” button located on the probe. As the scan progresses, sections of the bladder will appear on the console screen. When you hear the end-tone, the scan is complete. When you have 3 consistent readings and a clear image through scanner press print or take a photo of the scan image and results and download into the patients electronic record
- at the end of the procedure the scanner head should be wiped free of gel and cleaned with a wipe as per infection prevention and control (IPC) manual
- remove the remaining gel from the patient’s abdomen using wipes and allow the patient to redress
- ensure all waste is disposed of in line with waste policy
- decontaminate hands
- explain the results to the patient
- if bladder contains a residual of urine under 200mls, teach bladder emptying techniques. If residual greater than 200ml, check urea and electrolytes and rescan in 7 days. If residual remains above 200mls contact specialist continence service or urology for further advice (see appendix C flow chart for bladder scanning)
5 Training implications
5.1 Community nurses, planned or unplanned qualified care home colleagues, qualified colleagues at Tickhill Road Hospital
- How often should this be undertaken: Every other year.
- Length of training: Half day.
- Delivery method: Presentation practical.
- Training delivered by whom: Specialist continence sisters.
- Where are the records of attendance held: Electronic colleague record system (ESR).
6 References
- Addison, R. (2000) A guide to bladder ultrasound. Nursing Times Vol 96, No 40.
- Department of Health (DoH) (2001) Reference Guide to Consent to the Procedure. London, Crown.
- Department of Health (DoH) (2005) Essence of care. Benchmarking for Privacy and Dignity, Record Keeping, Continence and Bladder and Bowel Care.
- Department of Health (DoH) Essential Steps to Safe Clean Care (2007) Preventing the Spread of Infection.
- National Institute for Health and Care Excellence (NICE 2015) (NG123) Urinary Incontinence and pelvic organ prolapse in women: management.
- NMC (2015) Code of Professional Conduct, NMC, London.
- Lower urinary tract symptoms in men, management (NICE 2015) (CG97)
7 Appendices
Please see continence manual webpage for appendices attached to this procedure.
- Appendix C Flow chart for bladder scanning
Document control
- Version: 3.
- Unique reference number: 428.
- Approved by: Clinical policies review and approval group.
- Date approved: 7 January 2025.
- Name of originator or author: Team leader specialist continence service.
- Name of responsible individual: Chief nurse.
- Date issued: 3 February 2025.
- Review date: 31 January 2028.
- Target audience: All clinical colleagues.
- Description of change: Review, the procedure has not changed model changed to CUBEscan 700 and 900s, removed BVI 3000, and removed pregnancy on page 4.
Page last reviewed: February 06, 2025
Next review due: February 06, 2026
Problem with this page?
Please tell us about any problems you have found with this web page.
Report a problem